mode=5 (balance-tlb)Ĭhannel bonding that does not require any special switch support. Switches will require some type of configuration to enable 802.3ad mode. – A switch that supports IEEE 802.3ad Dynamic link aggregation. – Ethtool support in the base drivers for retrieving the speed and duplex of each slave.
Utilizes all slaves in the active aggregator Creates aggregation groups that share the same speedĪnd duplex settings. This mode provides load balancing and faultīroadcast policy: transmits everything on all slave interfaces. This selects the same slave for eachĭestination MAC address. Transmit based on. Is externally visible on only one port (network adapter) to avoidĬonfusing the switch. The other one willīecome active, only when the active slave fails. In this mode, only one slave in the bond is active. This mode provides loadīalancing and fault tolerance. It transmits packets in sequential order from theįirst available slave through the last. Additionally, link integrity monitoring, may beĪccording the to the official documentation, here is the types of network bonding modes.
Mode generally speaking, modes provide either hot standby or loadīalancing services. The behaviour of the bonded interfaces depends upon the The Linux bonding driver provides a method for combining multiple network interfaces into a single logical “bonded”
Linux allows us to bond multiple network interfaces into single interface using a special kernel module named bonding. Network bonding can be used in situations wherever you need redundancy,įault tolerance or load balancing networks. Unplugged, the other one will keep the network traffic up and alive. It will increase the network throughput,īandwidth and will give redundancy. Method of combining (joining) two or more network interfaces together
0 kommentar(er)
